Induction power supply
ABE-60AB
60kW
Shaft and bush hardening up to 80 mm diameter, plus billet and end heating.
ABE-60AB is specified for end heating, hardening, tempering and billet heating across hand tools and auto components.
We configure the ABE-60AB for shaft and bush hardening, including shaft diameters up to 80 mm, and for gears, JCB and tractor parts, axle shafts and flywheel rings.
We also build an ABE-60AB ultra high frequency variant, used for brazing work where a very shallow, very fast heat is wanted, and where the coupling distance between coil and joint is small.
Technical specifications
| Parameter | Specification |
|---|---|
| Output power | 60 kW. We confirm the duty cycle for your application. |
| Oscillation frequency | We select the frequency for your material, heating zone and required case depth. |
| Input power supply | We confirm the voltage, phase, frequency and connected load in your quotation. |
| Cooling water requirement | We specify the water flow, pressure, quality and cooling circuit for your machine configuration. |
| PLC / automation interface | Manual, PLC or CNC control options. We confirm communications and I/O with your automation requirements. |
| Compatible steels and alloys | We assess your material grade and heat treatment requirements before confirming suitability. |
| Maximum shaft diameter, hardening | 80 mm (3.15 in), subject to component and process review. |
| Switching technology | Solid-state IGBT |
Calculating required power? Run your cycle time on the Induction Power Estimator.
We select the frequency, dimensions, cooling and handling for your application. Send us your component drawing and required cycle time so we can confirm the complete machine specification.
Related processes
- Induction hardeningA hard, wear-resistant case on a tough core, in seconds, with the heat placed exactly where you want it.
- Induction brazingJoints that come out the same every time, because the heat is placed by a coil and timed by a machine.
- Induction temperingTrading a little hardness for a lot of toughness, in line with the hardening machine.
- Induction shrink fittingAssembling interference fits by expanding the outer part instead of forcing it on.
- Induction billet heatingSteel at forging temperature in seconds, paced to the press, with far less scale.
- Bar and end heatingHeating only the end of the bar that is about to be formed, and nothing else.
Related products
- Induction heating machinesIGBT power supplies from 5 kW to 500 kW, supplied standalone or built into a PLC or CNC controlled machine.
- Induction hardening machinesVertical and horizontal hardening machines for shafts, gears, bushes, axle shafts and flywheel rings.
- PLC controlled vertical hardening scannersA scanning hardening machine: the part traverses through the coil while quench follows behind it.
- Horizontal hardening machinesFor parts that must be supported along their length, or processed through stations in line.
- Induction brazing machinesRepeatable brazed joints with heat placed only where the filler must flow. Single and double station.
- Billet and bar heating systemsBillet heaters from 50 kW to 300 kW, and bar end heaters for forging lines.
Tell us about the part.
Send a drawing, the material, the case depth or temperature you need, and your production rate. Our engineers will help define the right machine for your process.